Dodge Challenger Forum banner

Whipple 426 build? How much power?

4K views 7 replies 5 participants last post by  McCloud 
#1 · (Edited)
Whipple 419 build? How much power?

The shop is in the process of finishing up my build and I would likely to get some input how much horsepower and torque I should realistically make? Keep in mind it's probably gonna be in the low to mid 90's when the car gets dyno tuned and I'm 22" wheels. Here's a short list of the engine mods

10.3 to 1 419 (previously installed)
2.9 Whipple on 10psi
6.1 ported heads (previously installed)
Blower cam ( specs 230/240 or 230/246 117lsa)
Arh 1 7/8th longtube headers with catless mids
3" Pypes Catback (previously installed )
Arrington 90mm throttle body (previously installed)
Shr Viking trans 5speed (previously installed)
3.73 getrag (previously installed)
Paramount 2800 stall converter
 
#6 ·
Whipple 419 build? How much power?

The shop is in the process of finishing up my build and I would likely to get some input how much horsepower and torque I should realistically make? Keep in mind it's probably gonna be in the low to mid 90's when the car gets dyno tuned and I'm 22" wheels. Here's a short list of the engine mods

10.3 to 1 419 (previously installed)
2.9 Whipple on 10psi
6.1 ported heads (previously installed)
Blower cam ( specs 230/240 or 230/246 117lsa)
Arh 1 7/8th longtube headers with catless mids
3" Pypes Catback (previously installed )
Arrington 90mm throttle body (previously installed)
Shr Viking trans 5speed (previously installed)
3.73 getrag (previously installed)
Paramount 2800 stall converter
is it stroker to 419 or is it bored.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top