Dodge Challenger Forum: Challenger & SRT8 Forums - View Profile: stevewhiteparts

stevewhiteparts stevewhiteparts is offline

Supporting Vendor

  Visitor Messages

Showing Visitor Messages 1 to 10 of 180
  1. kpapagno
    11-24-2016 09:04 PM - permalink
    kpapagno
    Hi Luke -

    Get I get a quote on an 8Y/100K, and 8/120K mopar maintenance contract for a '17 Challenger SRT? I can provide VIN if you need it.

    Thanks
    Ken
  2. thedude
    11-06-2016 12:08 PM - permalink
    thedude
    Luke. Any update on TA hood intake availability as a stand alone purchase.
  3. DodgeHemi61
    11-03-2016 04:44 PM - permalink
    DodgeHemi61
    Good morning Luke. I have a new 2016 Ram Rebel with the 5.7 engine and this is the first Dodge truck thatI have owned since 1976 that has a open rear differential, and living in Michigan, I need all the traction I can get at times. So my question is, If I decide I need a Sure grip or posi style differential, what would the cost of one be? I can install it with not problem.
    Or does this Rebel do a good job of using the abs brake system to slow down the tire that is spinning on the snow and ice?
    Thank you, Jim
  4. benmowery
    11-03-2016 07:13 AM - permalink
    benmowery
    During install of either of these there seems to be a plastic shield that either needs removed or modified. Do you guys remove it or modify it? There appears to be one on each side?
  5. Ts10r/t
    10-22-2016 05:41 PM - permalink
    Ts10r/t
    I was looking for a 345 hemi hood emblem along the lines of the old 426 hemi emblems that you guys have listed. I tried ebay and they aren't quiet what I am looking for. do you have any suggestions...
  6. DodgeHemi61
    09-23-2016 11:33 PM - permalink
    DodgeHemi61
    Thanks luke for taking the time to look up thetorque numbers for me.
  7. DodgeHemi61
    09-23-2016 11:31 PM - permalink
    DodgeHemi61
    Could you please answer a question for me about my truck? I have a 2007 Ram 1500 4x4 Sport Quad Cab with the 5.7 engine, and I am having a hard time finding the correct torque on the upper control arm bolts that mount the arms to the frame, and the upper ball joints. I am replacing both arms because the bushings are squeeking.
    I am reading numbers on the bolt torque that run between 120 and 200 lb/ft.
    And on the ball joints, torque them to 40 ft/lb then tighten them another 200 degrees to get around 220 lb/ft. This does not make since to me.
    Can you give me some correct numbers?
    Thank you
  8. benmowery
    09-14-2016 11:01 AM - permalink
    benmowery
    Any thoughts on which would be the better subframe connector for my 16' Scat Pack? I notice you sale the RE and also what looks like the Petty's garage bolt ins. Obviously I understand the weld ins are better, but which do you sale the most of what kind of feedback have you received with either?

    Ben Mowery
  9. Barbarossa
    08-23-2016 03:51 PM - permalink
    Barbarossa
    Tried to message you, but said the message was too long. so I made a post.

    Could you confirm if the bezel would indeed swap over?

    http://www.challengertalk.com/forums...5/#post6926697
  10. fatscat2015
    08-12-2016 02:21 PM - permalink
    fatscat2015
    can i get a tracking number ? i have emailed messeged on fb
    jeff castell i ordered yesterday.

  About Me

  • About stevewhiteparts
    Year
    2011
    Make
    dodge
    Model
    CHALLENGER
    Location
    NEWTON, NC
  • Signature
    THANK YOU FOR SHOPPING WITH US
    WE WILL NOT BE UNDERSOLD!!!!!!
    PLEASE VISIT
    WWW.STEVEWHITEPARTS.COM
    FOR THE BEST MOPAR PARTS PRICES ON THE INTERNET!!!!!!
    facebook.com/stevewhiteparts1
    828-324-4410
    800-779-3634

  Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 12-03-2016 10:42 AM
  • Join Date: 09-30-2011
  • Referrals: 1

  Friends

Showing Friends 1 to 10 of 51

  Mentions

11-23-2016
11:59 PM - Yahooligan mentioned stevewhiteparts in post Kornerstone Extended Warranty - Should I cancel?
...within the window. stevewhiteparts can verify and give ...
12:31 PM - praiseV8 mentioned stevewhiteparts in post Black Friday to Cyber Monday Specials....
stevewhiteparts Luke, Do you guys s...
11-07-2016
11:39 AM - stevewhiteparts mentioned DRiv in post And so it begins.....
...transformation for #driveusca 2017 season Spe...
11:38 AM - stevewhiteparts mentioned DRiv in post And so it begins.....
... transformation for DRiveusca 2017 season Spe...
09-13-2016
01:28 PM - Yahooligan mentioned stevewhiteparts in post 3.90 in a 392 Scat pack A8
...on what it shows at stevewhiteparts, who sells it for $7...
09-05-2016
01:09 PM - Yahooligan mentioned stevewhiteparts in post Factory Extended Warranty?
... Send your VIN to stevewhiteparts via PM and he'll get...
08-21-2016
01:47 PM - Yahooligan mentioned stevewhiteparts in post Lifetime Warranty. How many RT / SXT owners got it
...lling them. Contact stevewhiteparts here on the forums a...
08-17-2016
09:14 AM - Yahooligan mentioned stevewhiteparts in post Getting my clutch replaced
...OEM clutch kit from stevewhiteparts for under $500. That...
06-27-2016
01:29 PM - stevewhiteparts mentioned Kooks Headers in post And so it begins.....
...011 Challenger R/T @Kooks Headers and Cat Back - YouTu...
06-08-2016
08:57 PM - Yahooligan mentioned stevewhiteparts in post Lifetime Warranty SRT Motors
...l, bought from Luke stevewhiteparts , and that was 6-ish...
04-08-2016
08:34 AM - Yahooligan mentioned stevewhiteparts in post What did you do to your Challenger today??
... purchase them from stevewhiteparts, Speedlogix, etc. fo...
03-25-2016
04:43 PM - SuperchargedSP mentioned stevewhiteparts in post Too Much Negative Camber? Numbers posted...
...Luke Thanks Luke stevewhiteparts. I bought them from ...
03-20-2016
09:51 AM - Yahooligan mentioned stevewhiteparts in post Deleted Posts
02-25-2016
03:53 PM - Yahooligan mentioned stevewhiteparts in post Lifetime Warranties
...tended warranties. stevewhiteparts can give you a quote...
01-29-2016
03:30 PM - Yahooligan mentioned stevewhiteparts in post mopar vehicle protection lifetime maximum care
... from a dealer like stevewhiteparts that will give you a...
01-17-2016
10:58 AM - Yahooligan mentioned stevewhiteparts in post Can Someone Explain SRT Drive Modes
...index.html Contact stevewhiteparts for the best price o...
12-28-2015
01:29 PM - Yahooligan mentioned stevewhiteparts in post Clutch issue
...OEM clutch kit from stevewhiteparts, had the dealer do t...
12-11-2015
10:48 AM - Yahooligan mentioned stevewhiteparts in post Mopar Lifetime Vehicle Protection Plan
...ing around. Contact stevewhiteparts here on the forums t...
12-03-2015
03:49 PM - iHerbivore mentioned stevewhiteparts in post Mopar Lifetime Vehicle Protection Plan
... Have you tried stevewhiteparts? They have listed re...
08-03-2015
08:49 PM - Qjake17 mentioned stevewhiteparts in post Dealer replaced Gauge Cluster...Scat Pack Bee animation gone.
Speak with Luke stevewhiteparts

  Quotes

12-03-2016
10:39 AM - stevewhiteparts quoted Merlhagstrom in post 8.4 without nav?
Well it appears that my son's 8.4...
12-02-2016
09:01 AM - stevewhiteparts quoted Frank Julian in post 2015 5.7 to 6.4 swap
Luke I wasn't complaining, just s...
07:44 AM - Frank Julian quoted stevewhiteparts in post 2015 5.7 to 6.4 swap
the scat pack pcm usually take 2 to ...
07:24 AM - stevewhiteparts quoted Frank Julian in post 2015 5.7 to 6.4 swap
just ordered a scat pack 1 pcm la...
06:31 AM - Frank Julian quoted stevewhiteparts in post 2015 5.7 to 6.4 swap
yes, and have one in stock for sale>...
12-01-2016
01:36 PM - stevewhiteparts quoted Frank Julian in post 2015 5.7 to 6.4 swap
anyone do a 426 swap? Just curiou...
11-28-2016
07:46 AM - stevewhiteparts quoted Shake Me in post Black Friday to Cyber Monday Specials....
Could you tell me what the pr...
11-25-2016
12:14 PM - FreddyG quoted stevewhiteparts in post CAI rant/question............
... - Original Parts - SteveWhiteParts.com and use promo c...
09:42 AM - stevewhiteparts quoted Brewcitygymratt in post Hellcat Tube with Mopar Cold Air Intake System...
Our cars are absolute tanks, it woul...
11-24-2016
09:08 PM - philipswanson quoted stevewhiteparts in post 8.4A RA3 NAV Upgrade
this is the procedure and $565.00 ac...
11-23-2016
06:38 PM - Frank Julian quoted stevewhiteparts in post Black Friday to Cyber Monday Specials....
have to do an etc relearn once insta...
05:27 PM - 392Shaker1914 quoted stevewhiteparts in post Black Friday to Cyber Monday Specials....
[QUOTE=stevewhiteparts;7135658]pricing will...
04:23 PM - praiseV8 quoted stevewhiteparts in post Black Friday to Cyber Monday Specials....
... - Original Parts - SteveWhiteParts.com Awesome, than...
02:06 PM - stevewhiteparts quoted Frank Julian in post Black Friday to Cyber Monday Specials....
it has to go to the dealer, it wo...
02:04 PM - stevewhiteparts quoted Ucanthangwme in post Black Friday to Cyber Monday Specials....
Stock 392 fuel pump. Oem. what...
02:01 PM - stevewhiteparts quoted praiseV8 in post Black Friday to Cyber Monday Specials....
stevewhiteparts Luke, Do y...
07:38 AM - stevewhiteparts quoted Frank Julian in post Black Friday to Cyber Monday Specials....
Does it have to be all caps? y...
07:36 AM - stevewhiteparts quoted 80 Grit in post Black Friday to Cyber Monday Specials....
This is great. Going to have...
07:25 AM - stevewhiteparts quoted Ucanthangwme in post Black Friday to Cyber Monday Specials....
Need gaskets for some headers too...
07:23 AM - stevewhiteparts quoted Ucanthangwme in post Black Friday to Cyber Monday Specials....
Looking to get a 392 fuel pump fo...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
6
100.0%
Members who left positive:
Members who left negative:
6
0
Total positive feedback: 8
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome