Dodge Challenger Forum: Challenger & SRT8 Forums - Search Results
Advanced Search
Showing results 1 to 24 of 24
Search took 0.03 seconds.
Search: Posts Made By: deano379
Forum: Exterior Discussion / Modifications   03-22-2015, 03:39 PM
Replies: 8
Views: 442
Posted By deano379
LEDs

Some additional thoughts on the subject.

The Challenger uses 8, 3157 tungsten filument bulbs in the rear light modules even though the 4 in the center section only utilize the tail light element....
Forum: Exterior Discussion / Modifications   03-22-2015, 11:41 AM
Replies: 8
Views: 442
Posted By deano379
I have been using LEDs for tail/stop/turn signals...

I have been using LEDs for tail/stop/turn signals since 07 on a Charger and now on an 11 Challenger and a 96 Crown Vic.
You need to do some research and compare the many available bulbs.
In my...
Forum: Challenger Issues & Problems   02-08-2015, 11:47 AM
Replies: 10
Views: 452
Posted By deano379
The filaments of incandescent bulbs can break and...

The filaments of incandescent bulbs can break and separate. Vibration can cause the broken ends to contact, and if the power is on, the filament can weld itself together.
In my experience, this can...
Forum: 6.4L / 392ci (2011 - ?)   01-23-2015, 11:55 AM
Replies: 10
Views: 818
Posted By deano379
I found the best price on genuine Chrysler...

I found the best price on genuine Chrysler warranty for my Challenger and Jeep at "chryslerwarrantydirect.com"
Forum: Challenger Issues & Problems   12-20-2014, 12:19 PM
Replies: 5
Views: 788
Posted By deano379
Even though they are called 3 volt, when fresh...

Even though they are called 3 volt, when fresh they read 3.27 volts.
I have had the same problem with other electronics and a fresh battery makes it work.
Forum: 6.1L (2008 - 2010)   12-11-2014, 05:18 PM
Replies: 14
Views: 1,816
Posted By deano379
You are good to go with either one. However, I...

You are good to go with either one. However, I would use the 0w40 in the winter given the choice.
Forum: Bolt On's   11-30-2014, 11:59 AM
Replies: 5
Views: 441
Posted By deano379
You would have to adapt the 2 3/4" mid pipe to...

You would have to adapt the 2 3/4" mid pipe to the 2 1/2" R/T cat back.
A muffler shop can reduce the mid pipe to fit. Or, adapters are available.
Forum: Builds   11-21-2014, 04:11 PM
Replies: 15
Views: 1,453
Posted By deano379
Other than all of the work involved, be aware...

Other than all of the work involved, be aware that emmisions requirements are based on the year of the vehicle, not of the engine.
It may not be possible to bring the 440 up to 2011 standards.
Forum: 2015 R/T Scat Pack 392   11-07-2014, 09:05 PM
Replies: 69
Views: 12,024
Posted By deano379
Better view. ...

Better view.
http://www.challengertalk.com/gallery/data/500/medium/challenger_0053.jpg
Forum: General Challenger Discussion   11-02-2014, 11:51 AM
Replies: 28
Views: 2,106
Posted By deano379
Try removing the mufflers, but keep the...

Try removing the mufflers, but keep the resonators. Louder but no drone, according to another member who did this.
Forum: Audio, Video and other Car Electronics   10-11-2014, 05:41 PM
Replies: 2
Views: 378
Posted By deano379
I'm not an engineer but, there were LED...

I'm not an engineer but, there were LED replacement lamps that had built in resistors, they could go bad, but, both at the same time, unlikely. Check the wiring, you might find some resistors already...
Forum: Bolt On's   09-01-2014, 12:58 PM
Replies: 10
Views: 1,471
Posted By deano379
AEM drop in, better flow than OEM, better...

AEM drop in, better flow than OEM, better filtration than K&N and is dry (no oil) and washes clean.

http://www.aemintakes.com/air_filter/dodge_challenger.aspx
Forum: Bolt On's   09-01-2014, 12:38 PM
Replies: 8
Views: 1,008
Posted By deano379
Not to mention the flex joint behind the left...

Not to mention the flex joint behind the left side muffler is reduced to 2 1/8" from a
2 3/4" pipe. And, the OEM tips are 2 3/8"

The Corsa has smooth, large radius, full mandrel bends and full 2...
Forum: New Member Introductions   07-03-2014, 02:45 PM
Replies: 11
Views: 425
Posted By deano379
Also, from another guy from Utah.

Also, from another guy from Utah.
Forum: 6.4L / 392ci (2011 - ?)   03-30-2014, 10:44 AM
Replies: 74
Views: 5,818
Posted By deano379
And last but not least, the "SRT Experience" if...

And last but not least, the "SRT Experience" if you can go.
Forum: How-To, DIY and Tips & Tricks   03-11-2014, 11:12 AM
Replies: 17
Views: 3,208
Posted By deano379
This is how I converted the side markers to do...

This is how I converted the side markers to do both functions:

Yes, the lights still function as side markers

NOTE: If you have converted to LED bulbs you must have the "load" resistors for...
Forum: Bolt On's   10-15-2013, 11:43 AM
Replies: 4
Views: 678
Posted By deano379
Suggest you call a muffler shop and check if they...

Suggest you call a muffler shop and check if they can swage the Corsa X pipe from the
2 1/2" to 2 3/4" to fit over the Mid pipe.
Otherwise, 2 3/4" to 2 1/2" adapters are readily available. However,...
Forum: Challenger Issues & Problems   09-21-2013, 11:55 AM
Replies: 10
Views: 4,772
Posted By deano379
Guys, I found this when I needed a spare for...

Guys, I found this when I needed a spare for mine. https://ikeyless.com/vehicle/search/

Keep in mind though, if you lost your remote and just replace it, anyone who finds it can take your car.
...
Forum: 6.4L / 392ci (2011 - ?)   08-23-2013, 09:20 PM
Replies: 65
Views: 6,218
Posted By deano379
My car had one so I had no choice. I do not use...

My car had one so I had no choice. I do not use it.
If I was ordering new no way would I. More weight, something else to go wrong, potential leaks, less head room and more heat.
Forum: Wheels, Tires, Brakes, and Suspension   07-30-2013, 09:51 PM
Replies: 17
Views: 1,923
Posted By deano379
The larger rear tire will work OK on the front if...

The larger rear tire will work OK on the front if it is close in size.
I did the same, except I bought a used IE wheel to match the others.
I then bolted an old seat belt through the rear body...
Forum: Bolt On's   03-05-2013, 10:57 AM
Replies: 25
Views: 3,380
Posted By deano379
Solo

As I recall, the claimed increase was with the Solo Hi Flow mid-pipes and the cat back system.
Not saying the claim is accurate.
Any increase would also be dependent on any other mods.

I have...
Forum: Tuning/Data   02-02-2013, 12:53 PM
Replies: 4
Views: 734
Posted By deano379
Tune

Search for "Red Baron" and read about the B&G tune. The B&G disables the MDS and gives better performance across the board.
The Diablo Sport tuners are being offered with the B&G tune, that tells...
Forum: Off-Topic Discussion   12-05-2012, 09:26 PM
Replies: 56
Views: 2,598
Posted By deano379
As it was reported to me, Devin went out to his...

As it was reported to me, Devin went out to his car to get his gun and returned to the store where he confronted the robber.
Just because corporate has a policy does not make it right.
I applaud...
Forum: Dodge Challenger SE/SXT Specific   11-23-2012, 10:06 PM
Replies: 29
Views: 2,682
Posted By deano379
I installed a BBK 85mm on my 11 SRT. When...

I installed a BBK 85mm on my 11 SRT.
When looking in the inlet tube I could see steps molded in and could see and feel a constriction about an inch in from the TB. At the TB the inlet measured...
Showing results 1 to 24 of 24

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome