Do you have a part number for the caps that go on the back of the 2019 Scat Pack "Air Catcher tube"? I am looking to remove the front cap on the passenger side of my 2015 R/T to install either a billet ring or a lighted tube but I do not want the added road dirt. So my next question will they fit on a 2015?
I just want to start off by saying I truly appreciate all the help you give to others on this forum! It is greatly appreciated. I currently have a 2015 Dodge Challenger R/T without Heating/Ventilated seats. I recently purchased a set of Sepia seats with Heating/Ventilated option, and wanted to know what steps were needed in order to get it to work properly in my vehicle. Thanks in advance!
Good morning. Just following up with my bumper cover fog lamp project. Since I can not put the fog lamps into the srt/hellcat bumper cover can I change out the upper support on the rt cover, put in the srt upper support which would allow the use of the srt grill and allow me to keep the fog lamps?
i was told to reach out to you with a small problem. I have a 2017 dodge challenger rt. Im installing a new front air dam from an srt8. I purchased the new air dam and reinforcement but the dealer has no clue as to what hardware i need to install it or if my old hardware will work. Thanks in advance for your help. Im looking for the part numbers and amunts of what I will need.