Dodge Challenger Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi there, i know there are other threads displaying this topic but they're not very solid considering not to many people do this anyways except pure dedicated 3.5 owners.

But id like to start new.

So on the 3.5 V6 with Nag1 5 Speed Trans, Which is 198mm and allows 2.87, Im pretty positive the 4 speed 3.64 Ring and Pinion should be able to slide in there without any additions correct(Obviously swapping the old ones out)? Just wondering to make sure.

And where can i aquire a 3.64 198mm Ring and Pinion ive been searching everywhere? (Online atleast).

Id like some support for my built fellow mopar buds.

Better yet cant i just Swap the Pumpkins from a 2.87(My Car) to A 3.64 (Any Other 3.5 Dodge Vehicle aslong as its a 3.5 and 198mm, RWD)? Then Reprogram with my Predator Tuner Once installed?
 

·
Premium Member
The Bacon Hauler (‘12 Cop Charger)
Joined
·
9,440 Posts
Yeah, the pumpkin swap is the easiest way to go. Check local wrecking yards for open diffs (nonLSD)
 
1 - 2 of 2 Posts
Top