Dodge Challenger Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
I have a 1320 and want to remove the inside headlite block off plate. The plate normally pops off but this one doesnt move or twist off. I noticed 2 very small torx type screws (less than T10), do those have to come off first?
 

·
Registered
2018 Hellcat. 2017 Scatpack.
Joined
·
2,291 Posts
yep..have to remove the two tiny torx head screws and they then kinda 1/8 turn untwist, as the two inner ring tabs are hooked.
:)
 

Attachments

·
Registered
Joined
·
53 Posts
Discussion Starter #3
I had to order extra tiny torx bits (less than T10) to get screws out, Thanks!
 

·
Registered
Joined
·
53 Posts
Discussion Starter #4
With limited access, using a T9 torx bit, It took over a half hour to get the screws out, now I an install the Hellcat air box and tube. Thanks, Steve,
 
1 - 4 of 4 Posts
Top