Dodge Challenger Forum banner
Cancel

Billet Oil Catch Can installation issues on 2019 SP w/Shaker hood

1516 Views 9 Replies 6 Participants Last post by  Rob446, 
Southpaw392
Went to install my oil catch can from Billet w/z-bracket and ran into part of the wiring harness smack in the middle. The can will not fit properly and I do not think I could unscrew the can to empty. Anyone else have this issue?
997382
Save Share
Reply Quote
1 - 1 of 1 Posts
dh4ck3r

· Registered
Joined
·
83 Posts
#7 · (Edited)
I had a speedlogix one for my 19 Scat shaker and ran into the same issue. No matter what I did it was rubbing on wires and sat so low I couldn't get the bottom off to empty it. I switched to a UPR catch can and couldn't be happier with the fit and quality. Perfect fit for a shaker car.

Pic is from UPR website


Sent from my Pixel 4 XL using Tapatalk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Dodge Challenger Forum
Challenger Talk, the online forum for discussions, reviews of Dodge Challenger, and all things SRT, Hellcat, and Demon.
Full Forum Listing
Explore Our Forums
General Challenger Discussion Exterior Discussion / Modifications Performance Modifications Wheels, Tires, Brakes, and Suspension Dodge Challenger R/T Specific
Top