Can't Pair Phone

1051 Views 6 Replies 4 Participants Last post by NoCoHc, Oct 27, 2014

NoCoHc

Discussion Starter · Oct 26, 2014

My Iphone was paired with my car at the dealership when I picked up the car. Yesterday I did the radio reset, because my Sound Group II stereo sounded like crap. Stereo sounds better, but now I can't pair the phone. I also got a en error message telling me there is a phone problem and the computer needs to be flashed by the dealer. There was a similar glitch on my 2013 Ram. I kind of hate bluetooth anyway, but was hoping it would be better in a 2015. Any suggestions on a self fix?

Save

1 - 2 of 7 Posts

bwbike

· #2 · Oct 26, 2014

Make sure you have good reception (like outside). Go into the set up and put in your Uconnect password (again). I think the function is "change password," but you're really re-entering the original password. It's not obvious that the reset wiped it out.

Once that is in, and after a delay (can't remember how long), the pairing should be good once again.

Good luck!

Save

Reactions: 1

bwbike

· #5 · Oct 26, 2014

mz248 said:
Ok I don't recall entering a Uconnect password. I have not set up the U connect account yet. The dealer paired the phone without doing all of that, so I'm a little confused. Where would I find the original password is there some default maybe?

I didn't realize that paring the phone was different than Uconnect. Maybe the dealer used the 0000 when he set it up. :dunno:

Save

Reactions: 1

1 - 2 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month