Dodge Challenger Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,749 Posts
Discussion Starter #1
Having spent way too much time carefully prying off the ram's head center caps on my wife's FF R/T for replacement, here's what I did on the Hemi Orange R/T also in my garage. Rather than worry about scratching an expensive rim I simply drilled a hole in the cap and pryed it off from the center. Took about 3 minutes to do the entire car. No jacking and removal of the wheel, no worries about nicking the rim from prybars, the ram's head are going in the trash where they belong. Hope this helps.
 

Attachments

·
Registered
Joined
·
389 Posts
Good move - and excellent tip! Before I got my aftermarket wheels I was seriously considering just replacing the Ram's head center caps, but wasn't keen on jacking the car up, removing each tire one by one and doing the replacement that way, then putting it all back again. Brilliant!
 
1 - 4 of 4 Posts
Top