Dodge Challenger Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
640 Posts
Discussion Starter #1
I ordered a bumper cover from Duraflex, circuit style. Wanted the car to look different than factory style. I also purchased a front splitter and installed it over the weekend. The bumper cover is not for the inexperienced, thats for sure. No instructions and no hardware. Splitter actually runs under the car further back then the lower radiator support. Heres the results.
20200627_091231.jpg
20200627_091237_HDR.jpg
20200627_091244.jpg
20200627_091403_HDR.jpg
20200627_125257.jpg
20200627_125303.jpg
20200627_140219.jpg
20200627_140226_HDR.jpg
20200627_140228.jpg
20200627_152307.jpg

When i asked supplier about mounting splitter, they suggested two sided tape. I didnt go that route and drilled holes and used bolts
 

·
Premium Member
2015 RT, Scat Pack.......Shakerrrrrr
Joined
·
145 Posts
Interesting effort. What's the profile of your car look like with that new splitter look?
 

·
Registered
2015 RT Shaker (STP/A8/FORGED/NAPPA/NO SUNROOF)
Joined
·
463 Posts
The profile looks good. The front is growing on me too.
 

·
Registered
Joined
·
640 Posts
Discussion Starter #5
The profile looks good. The front is growing on me too.
Thanks. Ive still got to finish the lower grill. Have tried 3 or 4 already and dont like any of them so far. Think i got one that should look good, just have to finish it this week sometime
 
1 - 5 of 5 Posts
Top