[wbt]

Looking around and decided to try the fender-well CAI off of eBay for $50. Figured it was worth a shot and if it does not produce, will stick with plan to use Stack Performance CAI.

Will post pics next week once it arrives of the install. :thumbsup:

 

[Goehner]

Do you have a link to it? Should be interesting for sure.

 

[wbt]

Do you have a link to it? Should be interesting for sure.

Here is a link:

5.7 5.7L 6.1 6.1L V8 HEMI SRT8 COLD AIR INTAKE RED - eBay (item 280578179148 end time Jan-18-11 19:01:06 PST)

 

[IDMTfirefighter]

another member did a test of K&N, big bully, airaid (I think) and ebay CAI.
Name brands all performed very well and ebay gave decent hp gains for the performance.
a good investment for the budget minded modder

 

[Stoned Hemi 6]

Doesn't look like a bad product. I'm curious to know how it performs. I have the MOPAR CAI that I got using some of my MOPAR bucks. It's not bad but I liked the K&N that I had on my stone white RT a lot better.

 

[wbt]

another member did a test of K&N, big bully, airaid (I think) and ebay CAI.
Name brands all performed very well and ebay gave decent hp gains for the performance.
a good investment for the budget minded modder

Do you by chance have a link for those results? Thanks!

 

[IDMTfirefighter]

here yah go...

3.5L Intake Evaluation (E-Bay, K&N, Big Bully, Air Hammer HO)

this was done on a 3.5L and it was an air hammer not airaid.
a decent eval with pre and post dyno runs on all that where tested.
hope that helps with your decision.

 

[wbt]

here yah go...

3.5L Intake Evaluation (E-Bay, K&N, Big Bully, Air Hammer HO)

this was done on a 3.5L and it was an air hammer not airaid.
a decent eval with pre and post dyno runs on all that where tested.
hope that helps with your decision.

Interesting read thanks!

Looked like it performed well albeit a different motor and design than the one I chose to try.

I will not be doing a dyno comparison but will be making some runs at the track in the next week or so. :bigthumb:

 

[rayzazoo]

The ebay version is a 3.5" tube. I'd imagine this will have very similar results to the Jeep Cherokee SRT8 BWoody 3.5" Cold air intake.

 

[wbt]

**Update**

Got it installed this evening after work. Fit was good. No major snags. The breather hose that came with the kit was a little large so I used my own 1/2" hose for it. The hardest part was taking the bottom fascia loose to insert the lower pipe from the fender-well. A few pics:

Heading to the track tomorrow evening to get some baseline runs in. :thumbsup: