Finally got my Blower Accessory! A/F Gauge is home!
1 - 2 of 2 Posts
Joined
·
3,500 Posts
You probably already know this but put it pre cat as far up as you can between 12 - 2 drivers side
Have fine running the wire lol it was a blast for me lol
Sent from AutoGuide.com Free App
Have fine running the wire lol it was a blast for me lol
Sent from AutoGuide.com Free App
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Finally posting up My Build twin Turbo 6.4
Forced InductionSoooo as many of you all know I ran a nitrous based 5.7 for a couple of years now. If anyone does a search on my name you will find that I’ve product tested the MCLeod RXT clutch for the manual community( by this I mean I found out the hard way how terrible it is), I’ve done gear swaps, Cam...- 108
- 2K
-
DakBuilder · updated
-
6.2 cam swap into 5.7 M6 forced induction
Forced InductionI am looking to do the 6.2 cam swap into a 5.7. I know most say go aftermarket but that usually means VVT lock/limiter and a significant increase in cost. Not looking for maximum power but instead a budget swap as the NA 5.7 camshaft is not ideal for boost. Other than the cam, springs and...- 158
- 12K
-
ChallyTatum · updated
-
New guy...Scat or Hell?
Forced InductionHey guys, new to the forum (obviously) and in the market for a 2016-2017 ScatPak or Hellcat. If I bought the Scat, a blower would end up on the car regardless. So, do I start with the Hellcat from jump street or go Scat Pak then add the blower? Side note: I ran my own performance shop for 16+...- 20
- 2K
-
How to convert Magnuson 5.7 Kit to 8Psi?
Forced InductionI just ordered the TSV2300 for my '14. From research I know I need their 3.2" .440 offset pulley. But I've also heard I'll need a new belt. And I have no idea at what point in the install process that I make this conversion.- 16
- 692
-
toncey · updated
-
Whipple 2.9 Dyno Results
Forced Inductionknow there are a few posts on this but I thought I would share my info as well for another reference point for anyone looking at going the SC route. I ended up with 577 RWH and 485TQ to the wheels on the Mustang Dyno. I was told by the Dyno operator that the Dynojet and the Mustang use a...- 12
- 673
-
McCloud · updated
Join now to ask and comment!