Dodge Challenger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
Installing JBA Shorties on my se this weekend. Anyone know the torque specs on the header bolts and also is there a bolt sequence? Looked around and couldnt find any info :scratchhead:
 

·
Registered
Joined
·
3,532 Posts
I torqued mine by hand to Ugh!

there wasnt much room in there to get the gear wrench on. I certainly couldnt get a torque wrench in there on some of them so they were torqued to 'tight enough'
 

·
Registered
Joined
·
615 Posts
I installed the JBA's on my R/T. I think the torque number was 18 ft.lbs. for the 5.7. I'm not sure if it is different for the SE. Here is the sequence for the V8's. Again, not sure if it is different for the V6:



Hope this is somewhat helpful:bigthumb:
 
1 - 3 of 3 Posts
Top