Dodge Challenger Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
206 Posts
Discussion Starter #1
So I was removing the belt guides from my headrests and one of the little round clips that hold the guides on snapped in two.. I don't even know what they are called, they are like washers with gaps in them.. I'm trying to figure out what I can use in it's place, or even get a new one somewhere. Anyone have any ideas?

Thanks
 

·
Premium Member
Joined
·
3,553 Posts
You might take it in and see if they'll replace it as material failure. I had a plastic seat release replace free on a chevy that was 2 years old.
 

·
Registered
Joined
·
495 Posts
So I was removing the belt guides from my headrests and one of the little round clips that hold the guides on snapped in two.. I don't even know what they are called, they are like washers with gaps in them.. I'm trying to figure out what I can use in it's place, or even get a new one somewhere. Anyone have any ideas?

Thanks
Sure, go to McMaster-Carr and look under retaining rings.
They have exactly what you want. A well stocked ACE hardware might too.
 
1 - 4 of 4 Posts
Top