Dodge Challenger Forum banner
  • Hey everyone! Enter your ride HERE to be a part of October's Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
2015 RT 5.7 M6
Joined
·
10,205 Posts
Speaking of mills I should do this on my father's bridgeport. Only thing I need is a nice heavy duty rotating stage. My work got rid of the bridgeport (left behind when our internal R&D machine shop was dissolved). They did not want to pay to have it removed (did it myself over last Thanksgiving) and they gave it to me which I gave to my dad which matches his lathe I got him for $100 from a local community center of all places.
 

·
Registered
2010 R/T Classic 6M
Joined
·
1,299 Posts
I've been thinking about doing this with my porting tools, is there enough room to make it a 92mm opening without cutting into the gasket groove? I wanna use the hellcat TB when I go up to 12psi
 

·
Registered
Joined
·
68 Posts
Discussion Starter · #6 ·
I've been thinking about doing this with my porting tools, is there enough room to make it a 92mm opening without cutting into the gasket groove? I wanna use the hellcat TB when I go up to 12psi
There might be. Mine uses a o-ring and there was a bit left
 
1 - 6 of 6 Posts
Top