Spent the past two morning swapping a fresh manifold, injectors, and then all the swap wiring. Did I need two days? No. But sunny cold weather taking my time, and doing a clean install was more important Poking around doing research, people claim the 5.7 injectors are fine. I just...
Has been successfully done by a few folks. Hone out/clean up casting flash in the 392 intake runners and a Fastman T.B. maybe. Then I would get the PCM unlocked with a skilled chassis dyno tune to breathe a little new life into it.
Get someone with experience when honing. You can easily hog through the manifold material if not careful.
Is there an inexpensive/easy way to data log without voiding warranty?
'18 Scat Pack.
I already have an ODB bypass in the trunk and am not aposed to hooking up and driving around with my laptop. Bluetooth phone app would be easier but if a laptop app would be more powerful, I'm good with what...
Hope this is ok to post here, I was told to try here since the NAG1 was sold in the Challenger, and there's a lot more folks modifying Challengers than Durangos.
I'm looking for a shop or individual who might be able to handle the electronics & programming side of this transmission...
I have done some work on my 2019, Scat 1320, BES forger short block and Procharger. I am around 660 RWHP. I have kept it under 700 to protect my stock A 8 trans. Has anyone had experience with the MMX 160 degree trans thermostat
kit? I want to keep it working well until/if I go...
Hey anyone out there that has put a 6.4 can in a VVT 5.7. Did you reuse the 5.7 valve springs or did you use the 6.4 springs as well? I’m trying to figure out if the 6.4 springs can be used for this cam swap.
Sent from my iPhone using Tapatalk
Alfaobd is it possible to "line-lock" front tires via obd for burnouts ? How to do that ? Or its only possible via tazer ?
I have read somewhere that it is also possible to start "lightshow" via alfaobd. Do you know where to find this menu?
I will also read this thread How to add STP & Launch...