Dodge Challenger Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
149 Posts
Discussion Starter #1
Hello!
I need help with my hood badge. I want change my 6.1 HEMI in to 7.0 HEMI.
Soon my car will get stroker from PWR (it turn my 6.1 in to 7.0)
Where I can order new badge with those numbers?
THanks
 

·
Registered
Joined
·
149 Posts
Discussion Starter #2
need help! Please.

This is my chally


I want change my "6.1" in to "7.0" after I install stroker kit
 

·
Registered
Joined
·
9,272 Posts
lots of places sell those type of numbers...try google "chrome auto emblems/numbers"
 

·
Registered
Joined
·
149 Posts
Discussion Starter #5
Thanks!
But is it possible to buy "7.0" for my chally same size and quality like my "6.1"?
It should look like stock.
If somebody know where tell me please? Or nobody did not do it before?
 

·
Registered
Joined
·
461 Posts
Danko makes badges that appear far better than stock.

I've got a set on my 5.7L Challenger - 345 HEMI (cubic inches) the "HEMI" is in red.

I also had Danko make some 419 HEMI badges for my stroked Magnum, with the "HEMI" in orange.
I calculated the displacement from the actual build sheet. It was a new 6.1L motor that was not over-bored, but was stroked to 4.051" [10.3cm]. This calculated to be 418.5 cu.in. or 6.858 liters (not 7.0 liters, but when speaking liters I call it a 6.9L motor)
 

·
Registered
Joined
·
149 Posts
Discussion Starter #7
Maybe you are right. I ordered "7.0 Rottating assembly"
So after this I make a decision that my engine will be 7.0
 

·
Registered
Joined
·
461 Posts
Here's a pic of my 419 HEMI hood badge and in the background you might be able to see the 345 HEMI badge on the Challenger




Added a pic of the Challenger (a little dark in the garage)

 
1 - 8 of 8 Posts
Top