Dodge Challenger Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
874 Posts
It shows at 11.5ish inches tall. I believe a stock eagle is around 8.5 ish.

Don’t expect it to fit under a stock hood lol

I’ve been thinking about one for my 06 charger and cutting a hole in the hood like all the cool corvette guys lol.


Sent from my iPhone using Tapatalk
 

·
Registered
2015 SRT 392
Joined
·
3,647 Posts
Discussion Starter · #6 ·
I know a couple of the Cool Corvette Guys that have done just that. Their Vettes are making between 1200-1800 rwhp, so it's not just for show. Most of them use a Wilson intake and a bolt on elbow to mount the throttle body. This is similar and actually quite a bit cheaper than the Wilson setup.

I agree that it's tall and I think that on a stroker motor, it would make some power. We''ll see though as they get out there and tested.

Newoldchallenger: That would look pretty Cool popping through the hood of your Charger.
 

·
Super Moderator
Joined
·
17,434 Posts
"maybe" with a T/A hood or Hellcat ('15 - '18) hood - those have the bumped up center section for the supercharger for the 'Cat

- remember, the older 60s/70s cars have lower hoodlines than the modern cars.

But the position of the throttle body could be a factor in some instances.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top