Dodge Challenger Forum banner

Oil change

1410 Views 13 Replies 6 Participants Last post by  Fahad khan
  1. Hi All I am have US specs challenger 2012 V6 model just before 2 months I have changed engine oil (Mobil 1) 25W50 and drove the car around 1500 KM now the car showing me change oil message? anyone can advise what's going on or do I need to use another oil
1 - 1 of 1 Posts

· Super Moderator
Joined
·
18,931 Posts
Try re-setting it again. Did you follow this procedure?

Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position or cycle the ignition to the ON/RUN position if
equipped with Keyless Enter-N-Go. To turn off the
message temporarily, press and release the MENU button.
To reset the oil change indicator system (after
performing the scheduled maintenance) refer to the following
procedure.

Vehicles Equipped With Keyless Enter-N-Go

1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (Do not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pressing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF/LOCK position.

Vehicles Not Equipped With Keyless Enter-N-Go

1. Turn the ignition switch to the ON/RUN position (Do
not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top