Dodge Challenger Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,539 Posts
Discussion Starter #1
I got some LEDS and on one of them both wires that were soldered to the board were basically touching so I put silicone on them to insulate...is this okay and safe? I was worried about any acidicness, it works fine...but just making sure it's a-ok, I used Permatex RTV Adhesive Silicone around the solder points as I couldn't get heat shrink or electrical tape over it
 
1 - 1 of 1 Posts
Top