Dodge Challenger Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,934 Posts
Discussion Starter #1
where can I get one for 2011 SRT8-392 Tremec Tranny?
Would one I have from my '04 Vette with Tremec fit?
 

·
Registered
Joined
·
977 Posts
From what I can tell.... they use the same Tremec 6060 in Caddy, Camaro, Mustang and Challenger. I just installed one I got off Ebay for $10 and $4 shipping. It takes all of 10 mins to install. Check my install in the DIY section.
 

·
Premium Member
2012 Challenger SRT in BSP
Joined
·
440 Posts
From what I can tell.... they use the same Tremec 6060 in Caddy, Camaro, Mustang and Challenger. I just installed one I got off Ebay for $10 and $4 shipping. It takes all of 10 mins to install. Check my install in the DIY section.
It's the same transmission but they use different solenoids which have a different impedance. The GM SSE plug has a much higher resistance and will result in a Check Engine Light so be sure to get the one intended for your Dodge.

I know first hand... :)

The GM SSE resistance to prevent the CEL is 2,200 ohms. For Dodge it's 250 ohms.

Helpful info at Speedy's Garage
 

·
Registered
Joined
·
977 Posts
Kool.... I stand corrected.

OBTW - I did order mine as a 2010 Challenger
 
1 - 7 of 7 Posts
Top