Dodge Challenger Forum banner

1 - 1 of 1 Posts

·
Registered
2018 Challenger SXT Plus
Joined
·
8 Posts
Discussion Starter #1
The mounting bracket on my stock intake assembly was broken off on my 2018 SXT. So I was looking for a replacement, and I really only needed the bottom half of the housing.

Nuke had an assembly from his 2011 V6 that he sent me after noticing they looked the same except the lid.
MOPAR lists the assemblies as different part numbers between these years, but it is only the lid that is different. The inlet on the lid is in a slightly different position.
The lower portions are identical and the 2011 part fit perfectly in my 2018.

This is oddly specific info, but I figured it might help someone else some day.

Shout out to Nuke for letting me have the assembly for free! Good dude right there.
 
1 - 1 of 1 Posts
Top