Dodge Challenger Forum banner
1 - 1 of 9 Posts

· Registered
24 Posts
Let me know

I've been fighting with it for a couple of hours, figured I'd jump on here and ask if anyone has any good ideas...

Started with the lower bumper grille. Besides it being PITA to get to, I'm not sure exactly how the T-Rex grille is supposed to fit against the stock one. The T-Rex edge is covered in rubber, is this supposed to "slide in" the small gaps in the stock grill? If so, how tight? So far, the best I've been able to do is get the T-Rex edge against the stock grille, I'm not sure if this is correct or not.

The other issue I'm having is, the T-Rex grille seems to be about 1" too short so I think I'm going to have to get one corner on, then do my best to stretch it as I go until it (hopefully) gets to the other corner. Because it's mesh, this doesn't seem to be a problem, I just wanted to make sure this is the proper way. Thanks.
I was thinking of getting the same pieces you have for my grill as well. Let me know how it goes getting it installed please.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.