[Loud_H3mi]

Hello everybody, I got a 2015 Dodge Challenger RT with H and R lowering springs.
Trying to figure out how to read alignment report, so I can Install SBC rear camber bushings at the proper +/- degrees.

 

[trippytro]

So you want the camber in the -1 to -1.5 range if you still want some camber and additional handling

If you just want your tires straight and to wear perfect, you want the rear camber -1 or less. I am think factory is like -0.8

Depending how you clock the bushing during install, it will give you.5 increments for your camber

Sent from my IN2025 using Tapatalk

 

[Loud_H3mi]

Thanks trippy, so right rear camber bushings should be installed in the 1.5 degree position and the left rear in the 1 degree position?

 

[trippytro]

Thanks trippy, so right rear camber bushings should be installed in the 1.5 degree position and the left rear in the 1 degree position?

Yeah just about if you want to get her back to "stock" specs .

Sent from my IN2025 using Tapatalk

 

[Loud_H3mi]

Yeah , trying to get the most mileage from tires. Thanks again trippy✌