Dodge Challenger Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
88 Posts
Discussion Starter · #1 · (Edited)
I have about 8000 songs on a USB3 thumb drive.
It is in the console USB port.
When car starts, it shows white box on screen saying its scanning the drive.
It is reading mp3 tags in files and updating the radio's database.
It takes 3 to 4 minutes of this before a song can be played.
So I pull in to get gas on the way to work and shut off the car.
Start car to complete drive to work.
Now it does another scan which causes another 4 minutes with no music.

Is there any way to cancel the second scan since no files changed during the 3 minutes the car was off? Just cancel the scan and assume the database is still correct.

Radio is 430N RHB with latest firmware version 50.
 

· Registered
Joined
·
88 Posts
Discussion Starter · #3 · (Edited)
internal drive is too small for that many songs.
also when I opted to compromise on having fewer songs available and tried the internal drive, I noticed that the playlists aren't shown at all.
 

· Premium Member
Joined
·
7,506 Posts
Try several smaller thumb drives and only put ~1,000 on each. Swap 'em out when you want different music.
 

· Registered
Joined
·
88 Posts
Discussion Starter · #6 ·
I will thin down the number of songs to try to get the scan time down to 2 minutes.
At that point, I am sure they would all fit on the hard drive.
But then it wouldn't use all the m3u playlists that I rely on.
 

· Registered
Joined
·
88 Posts
Discussion Starter · #8 ·
Sub folders by album.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top