very interesting, how do you plan on sealing the headlight from the front? In my experience with several projector retrofits, even the smallest seal imperfection will cause an ugly moisture issue

 

they are vented in the back stock .I have acrylic glue at the shop or maybe silicon sealer?

 

personally I would go with clear RTV Silicone around it, applied in the neatest yet thickest way possible

http://www.autozone.com/sealants-gl...dhesive/permatex-3-oz-85-g-tube-clear-rtv-silicone-adhesive-sealant/526764_0_0/

 

well heating in the oven is not working what are you guys using to cut the lens off
messing it up tooooo bad?? it up??

 

Yeah unlike all other headlights I cracked open in the past these were the worst by far, some people go straight to cutting the lense out with a dremel, I heated mine in the oven for 15 minutes then with a few screwdrivers and a heat gun worked a few inches at a time, the black housing part ended up getting screwed up in some areas but after I was done, I got a huge tube of black silicone masking into caulk gun and sealed the crap out of them, headlights are hidden under the covers so can never tell

 

only picture I have that you can see some of the edges, they dont come out bad at all, and even if you break through the plastic part it will be fine with the sealer

 

well 350 was to hot!!
looking or another light to start over on


I will cut it off next time !!!!

 

yeah when I have "baked" other brand headlights I would just set the oven to "warm" usually 150-200 degrees, 350 is just gonna make a puddle

 

Anyone have a driver side light to donate, since I melted this one??in till it melted I was doing fine .

 

I am thinking to get the bend needed to use vent hose, And a 3 inch PVC coupler.


I still need a driver side headlight for final fitting .

 

What were you gonna do with the turn signal?

 

halos for park & turn sig . and use the pass side for cool air to the engine compartment for cooling maybe??

 

anyone have an old driver side light to donate. I have gone as far as I can with the pass side I was given.

 

following this project, had the same idea myself, pvc for the inlets and halos for turn signals. I'd like to do a dual intake though with both lights.

 

Yea I am Plaining on both sides open when I get to the final fitting. I am looking for a driver’s side now, I have gone as far as I can with the pass side.