[Kennethjohn09]

This is the problem why the induction kit won’t work

 

[Kennethjohn09]

I wonder if I could replace the breather hose with this.

http://www.speedlogixstore.com/product-p/sx-blp-mopar.htm?CartID=1

 

[Kennethjohn09]

There’s no way i could fit the tube for the shaker to the airbox. Any tips would be appreciated

 

[Mopar Frank]

you could remove it and put a breather on the nipple on the engine end. People do it on the 5.7l when adding the 6.2l half covers.

 

[Kennethjohn09]

Are those legal in California?

 

[Kennethjohn09]

And there this hard tube with nylon sleeve. If i could bury the induction kit in this small space that would solve it

 

[Kennethjohn09]

Could use some tips here

 

[Kennethjohn09]

It is all mounted. I managed to fabricate a bracket for it. I just need it to be functional. By installing the induction tube.

 

[A Guy]

You've confirmed the height to seal against a shaker hood? You'll have to make a write up of what you did, and part #s when you are done. Would really assist anyone else going down the right path

A Guy

 

[Kennethjohn09]

I’ll make a list and instructions. Once I received my hood. I went to the dealership to look at the scat pack shaker. And i measure its height. Mine is just couple inches high, since the shaker have a rubber thingy around it, i assume that rubber would adapt to the excessive height of the shaker to the hood when its close

 

[Mopar Frank]

Really good work so far, first time you close the hood, you are going to be nervous.

 

[Kennethjohn09]

Annnd the shaker is sitting high hood wont close. Need to redesign the plate

 

[Kennethjohn09]

Alright guys i give up. A lot of money gone wasted. Im just gonna wait for danko

 

[A Guy]

It was my thought just eyeballing that the shaker would be too tall on the V6. But thought with it sitting as low as it could go...

Perhaps if the base was cut off the shaker itself...

A Guy

 

[Kennethjohn09]

Im just gonna make my own shaker base

 

[Kennethjohn09]

Is danko making one for the v6?

 

[Kennethjohn09]

I got it mounted on the engine cover, but under it is open to the engine. I’ll try to make a plate, mad of Aluminium sheet.

 

[A Guy]

Well that's a good start

A Guy

 

[sdr2711]

Agreed. Great start. Just wish it were easier.

 

[Kennethjohn09]

So trimmed the shaker base and that did it, i have the bracket and the bracket that i made weld together. Now im question is will the rubber grommets that came from the engine cover melt by contacting on the steel?