Dodge Challenger Forum banner

Key Fob battery replacement

2 reading
35K views 10 replies 9 participants last post by  Jaybird  
#1 ·
I got low battery fob message is this as easy as just changing the battery? Anything that needs to be reprogrammed? Car is 4 years old. I have both fobs only use one. 2019 Scat Pack

Thanks in advance
 
#4 ·
CR2032 battery.

Remove the mechanical key and use the tip to pop the case open.
 
  • Like
Reactions: 2020GoMango
#7 ·
Interesting timing. I just received the 'weak message' a few days ago. 3 years and 1 month for mine. Ultra cheap on ebay w/ free shipping. Name brands too as I don't buy the mongrel stuff. I bought Energizers for $2.65 for two.
 
#8 ·
I store my spare fobs with the batteries removed.
 
#9 ·
Both my fobs are always in the Fobguard pouches when I'm at home. No communication to wear down the batteries. 1st change was at 3 years and second about the same. One fob never used

A Guy
 
  • Like
Reactions: 2020GoMango
#10 ·
The battery in the key fob is a Panasonic CR2032. You can buy them cheap on EBay.

The replacement steps are very easy (don't go to the dealer):

1. Remove the valet key by pushing on the slide and pulling it straight out.
2. Using a thin-bladed screwdriver or a knife edge, unsnap the key fob by
gently prying around all of the edges.
3. One the key fob splits apart, simply pull out the old battery and insert the
new one. (Don't worry, unlike some watches, there are no loose parts
inside).
4. Handle the new battery around the edges and push it into place using
your thumb and index finger (Tip- Use a small piece of paper towel, or rubber gloves, to
avoid getting any hand oil on the new battery and angle the battery in
towards the silver retaining clips).
5. Align the two halves of the key fob and snap them together.
6. Reinsert your valet key.
7. Test your locks to insure that they are working.

You are done (less than 5 minutes)!

Image